Verified Solution • 2025–26 Session moderate

QP 114-116: Q19: HC Verma: Concepts of Physics - Volume 1 Chapter-7 Circular Motion P 114-116: Q19 Solution: A motorcycle has to move with a constant speed on an over…

⚠️ Common Exam Traps & Conceptual Pitfalls

Students often incorrectly use $mg$ instead of $mg\cos\theta$ in the radial force equation for points other than the apex, failing to recognize that only the radial component of gravity contributes to the centripetal force. Always resolve gravity into radial and tangential components relative to the instantaneous position on the arc.

A motorcycle has to move with a constant speed on an over bridge which is in the form of a circular arc of radius R and has a total length L. Suppose the motorcycle starts from the highest point. (a) What can its maximum velocity be for which the contact with the road is not broken at the highest point? (b) If the motorcycle goes at speed 1/21/\sqrt{2} times the maximum found in part (a), where will it lose the contact with the road? (c) What maximum uniform speed can it maintain on the bridge if it does not lose contact anywhere on the bridge?

Step-by-Step Verified Solution

**Answer:** **(a) vmax⁡=Rgv_{\max}=\sqrt{Rg}; (b) contact is lost at an arc distance πR/3\pi R/3 from the highest point; (c) vmax⁡=Rgcos⁡(L/2R)v_{\max}=\sqrt{Rg\cos(L/2R)}.** ### **Step-by-Step Explanation** 1. **Highest Point Condition** At the highest point of the convex bridge, the limiting condition is N=0N=0:
mg=mv2Rmg=\frac{mv^2}{R}
Hence,
vmax⁡=Rgv_{\max}=\sqrt{Rg}
2. **Loss of Contact for v=Rg/2v=\sqrt{Rg/2}** At angular displacement ϕ\phi from the highest point,
mgcos⁡ϕ=mv2Rmg\cos\phi=\frac{mv^2}{R}
Substituting v2=Rg/2v^2=Rg/2,
cos⁡ϕ=12\cos\phi=\frac12
Therefore,
ϕ=π3\phi=\frac{\pi}{3}
and the arc distance is
s=Rϕ=πR3s=R\phi=\frac{\pi R}{3}
3. **Maximum Uniform Speed Over the Whole Bridge** If the bridge has total arc length LL, the largest angle from the top is
ϕ=L2R\phi=\frac{L}{2R}
The most restrictive point is the end of the bridge:
mgcos⁡(L2R)=mv2Rmg\cos\left(\frac{L}{2R}\right)=\frac{mv^2}{R}
4. **Conclusion** Thus,
vmax⁡=Rgcos⁡(L2R)v_{\max}=\sqrt{Rg\cos\left(\frac{L}{2R}\right)}
provided the stated bridge geometry is the circular arc shown in the HC Verma figure.

All Questions in this Chapter

Related Learning Resources & Exam Preparation